TECHNICAL INFORMATION
• Materials: Acrylic composite
• Power Supply: 110V
• Dimensions: 51x29x42
• Water Usage: 50-55 gallons

PLUMBING REQUIRMENTS
• Unit is equipped with flexible, metal braided ½ inch water supply hose with ½ female threaded connectors
• Need to install hot and cold shutoffs with ½ male threaded nipples (not included)
• 1-1/2 drain with 90 degree angle
• Thermostatic valve may need to be recalibrated
• It is advised to have tub onsite before preparing drain location.

ELECTRICAL REQUIREMENTS FOR HEATED AIR PUMP
• Air jet motor with heater 110 volt
• 12-2 wire with 110 volt, 15-20 amp GFCI breaker

ELECTRICAL REQUIREMENTS FOR SYLLENT BRAND PUMP
• 3/4 HP water pump with heater
• 12-2 wire with 110 volt, 20 amp GFCI breaker

GENERAL INFORMATION
• Note: It is advised to have the tub onsite before preparing drain location.
• Unit must be leveled in its permanent position and all feet must be on the ground to fully support the tub